Clock-audio Non wireless bases Manuel d'utilisateur télécharger pdf (Page 3)

Push to Mute

This option will allow the microphone to be always live until the touch switch is

continuously held / pressed.

Note: It’s important to ensure that any touch switch input operations are made within

2 seconds after seeing either slow or rapid flashing of the led indicator. Failure to do

so will prevent the correct programming taking place. Simply switch the power off for

5 seconds and start again.

Setting Programme mode

Press and hold down the touch switch and at same time slide the power

switch to its on position then immediately release the touch switch. The

red led will rapidly flash. If it does not then switch power off and wait a few

seconds then try again. Do not proceed until you see rapid flashing of the

led.

Changing the Programme

After the red led stops rapidly flashing press the touch switch once and wait

for the led to flash then press the touch switch once again. Now wait for the

led to flash followed by rapid flashing. Press touch switch twice wait for flash,

press touch switch twice again wait for flash followed by rapid flashing. Press

touch switch twice wait for flash, press touch switch again twice wait for flash

followed by rapid flashing. After the flashing stops wait a further 15 seconds to

allow the new data to be programmed into the processor. The wireless base

has now been set to PTM and can now be used.

Easy programme steps

 Set programme mode as detailed above (identified by rapid flashing)

 Press once and wait for flash.

 Press once wait for flash then rapid flashing.

 Press twice and wait for flash.

 Press twice and wait for flash followed by rapid flashing.

 Press twice wait for flash

 Press twice wait for flash followed by rapid flashing.

 Wait 15 seconds before using.

1 2 3 4 5 6 7

Pas de commentaire

Clock-audio Non wireless bases Manuel d'utilisateur Page 3