Clock-audio Non wireless bases Manuel d'utilisateur télécharger pdf

Programming wireless and non wireless microphone bases

Listed below are shown all the programmes used to cover the many models used for

both wireless and non wireless microphone bases. Some of the options shown may

not be applicable to your model and cannot be programmed.

Latching / Normally off (Press touch switch for microphone to be Live)

This option will allow the microphone to be live when the touch switch is pressed.

Press touch switch again to mute the microphone.

Note: It’s important to ensure that any touch switch input operations are made within

2 seconds after seeing either slow or rapid flashing of the led indicator. Failure to do

so will prevent the correct programming taking place. Simply switch the power off for

5 seconds and start again.

Setting Programme mode

Press and hold down the touch switch and at same time slide the power

switch to its on position then immediately release the touch switch. The

red led will rapidly flash. If it does not then switch power off and wait a few

seconds then try again. Do not proceed until you see rapid flashing of the

led.

Changing the Programme

After the red led stops rapidly flashing press the touch switch once and wait

for the led to flash then press the touch switch twice and wait for led to flash

then wait for led to rapidly flash. Now press twice and wait for flash then

press once and wait for flash then wait for rapid flashing. Wait a further 15

seconds to allow the new data to be programmed into the processor. The

wireless base has now been set to latching / normally off and can now be

used.

Easy programme steps

 Set programme mode as detailed above (identified by rapid flashing)

 Press once and wait for flash.

 Press twice and wait for flash followed by rapid flashing.

 Press twice and wait for flash

 Press once and wait for flash followed by rapid flashing then wait 15

seconds before using.

1 2 3 4 5 6 7

SM08022012 7

Résumé du contenu

Page 1

Programming wireless and non wireless microphone bases Listed below are shown all the programmes used to cover the many models used for both wireless

Page 2

Latching / Normally on (Press touch switch to mute the microphone) This option will allow the microphone to be always live when powered up. Press touc

Page 3

Push to Mute This option will allow the microphone to be always live until the touch switch is continuously held / pressed. Note: It’s important to e

Page 4

Push to Talk set up (Press touch switch for microphone to be Live) This option will allow the microphone to be live only whilst the touch switch is be

Page 5

Beep On sound This option will transmit a short beep sound each time the touch switch is pressed to engage / make the microphone live. Note: It’s imp

Page 6

Beep off This option will remove the beep sound each time the touch switch is pressed to engage / make the microphone live. Note: It’s important to e

Page 7 - SM08022012

END SM08022012

Commentaires sur ces manuels

Pas de commentaire

Clock-audio Non wireless bases Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Communication Clock-audio Non wireless bases. Clock Audio Non wireless bases User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Communication Clock-audio Non wireless bases